What to notice
A falling evening temperature approaches a relatively steady dew point before dew or fog becomes possible.
What is happening?
The dew point is the temperature to which air would need to be cooled at constant pressure and water-vapour content to reach saturation with respect to liquid water. A higher dew point normally indicates more vapour at a given pressure. Unlike relative humidity, it does not fall merely because the same parcel is heated. That makes it helpful when comparing the moisture of different air masses.
The temperature–dew-point spread indicates how much cooling is needed for saturation under those assumptions. A small spread suggests the air is close to saturation. However, reaching saturation at a surface, throughout a shallow layer or inside a rising cloud are different situations. A thermometer a couple of metres above grass can remain warmer than the grass itself, allowing dew or frost on the surface before the reported air becomes saturated.
Basis: UCAR Center for Science Education [1] · NOAA / National Weather Service [2] · NOAA / National Weather Service [3]
Read the observation
- Record the spread as well as the two individual temperatures.
- Use a consistent pressure and time when comparing air masses.
- Distinguish dew point over liquid water from frost point over ice.
Dew point is not the temperature that air must reach tomorrow, nor is it automatically the temperature of every nearby surface.
Go a little deeper
In a rising unsaturated parcel, pressure decreases and dew point also usually decreases. The parcel temperature falls faster, allowing the two values to converge. This is why cloud-base estimates use their initial difference rather than assuming dew point stays fixed all the way upward. A rule of thumb of roughly 125 metres per degree Celsius of initial spread is a limited parcel estimate, not a measured ceiling.
In the moisture lab, keep “Starting temperature” and “Starting relative humidity” unchanged, then increase “Cooling applied” to move the parcel toward its calculated dew point. Changing the starting-temperature control alone would instead redefine the initial moisture state at the selected relative humidity. Next open the rising-air lab and compare a lifting path. These are different experiments: one approximates cooling at fixed pressure, the other expansion during ascent. Mixing their assumptions can produce a cloud-height claim unsupported by either calculation.
Basis: UCAR Center for Science Education [1] · NOAA / National Weather Service [2] · NOAA / National Weather Service [3]
Sources & provenance
- Humidity UCAR Center for Science Education · Publication date not statedReference only; original paraphrase; no source media reproduced.
- How Clouds Form NOAA / National Weather Service · Publication date not statedReference only; original paraphrase; no source media reproduced. JetStream permits broad use of its materials; separate credits are not assumed cleared.
- Parcel Theory NOAA / National Weather Service · Publication date not statedReference only; original paraphrase; no source media reproduced. JetStream permits broad use of its materials; separate credits are not assumed cleared.
Explanations and diagrams are original educational interpretations. Source institutions have not endorsed or reviewed this publication. How we distinguish evidence from models.